BIGTREETECH EZ2209 Step Driver

The EZ2209 from BigTreeTech's EZ series has the more modern TMC2209 on board, which does support StallGuard compared to the TMC2208. Thanks to the 1/256 step interpolation, a good 3D printing experience can also be achieved on less powerful electronic boards. The parameters of the TMC2208 chip can be further optimized through a UART link to your microprocessor. With this module you can supply up to 2A current and works on 12 to 24 Volt.

BigTreeTech's EZ series has a compact design for various stepper motor drivers and is suitable for the EZ versions of their electronics board range. If you already have an electronics board with Pololu-compatible 2x8-pin slots, you can use the BigTreeTech EZ-Driver Connector to connect the EZ-drivers.