With this motherboard you can easily upgrade your Creality 3D printer. You only replace the motherboard within a few minutes, after which you can immediately start working with your improved 3D printer!
This upgrade improves the following performance:
- The motherboard with TMC2225 driver makes your printer run a lot quieter
- +50% printing precision
- -40% power consumption
Other characteristics:
- MCU 32 bit
- Easy installation of your Antclabs BLTouch Leveling Sensor
- Bootloader installed (ISP/USB Arduino)
- Firmware 4.2.7 is preinstalled on this board
- The board is pre-installed for the Ender-3, but also suitable for the Ender-3 V2, Ender-3 Pro and Ender 5.
CAUTION: Always install the latest firmware for your printer.