This complete V6 hot end kit for your RepRap 3D printer contains all the parts for the V6 hot end (1.75mm), which allows printing at higher temperatures. The hotend kit comes with a
thermocouple, capable of reaching temperatures of up to 400°C (additional electronics may be required to support this).
The kit contains the following parts:
- E3D aluminium heater block.
- E3D heat break.
- E3D brass nozzle (0.4mm).
- E3D injection molded fan duct.
- Axial fan 30 x 30 x 10mm 12V.
- Thermocouple type K.
- Ceramic heating cartridge 12V.
- E3D aluminium heat sink.
- PTFE tube, 10cm.
- Fasteners.