The Chimera+ is a versatile hotend with two filaments and two nozzles. It is a versatile dual extrusion system that can print two different types of filament at the same time. The water-cooled Chimera+ kit is useful for heated build rooms where air cooling is not suitable, such as at ambient temperatures above 40°C. With the kit you can print materials such as PEEK at a high temperature. The Chimera+ can reach a maximum temperature of 300°C and is compatible with the E3D ecosystem.
This kit contains the following parts:
- 1x water-cooled HeatSink
- 1x Cylops+ mounting kit
- 1x 30x30x10mm 24V
- 2x V6 silicone socks
- 2x PTFE tube 800mm
- 2x brass nozzles 0.4mm 1.75mm
- 2x V6 Aluminum Heater Blocks
- 2x V6 mounting sets
- 2x 30W heating cartridge 24V
- 2x thermistor cartridge
- 2x thermistor extension cable
- Collet clips
