This complete v6 hot end kit for your RepRap 3D printer contains all parts for the v6 hotend (1.75mm). This allows printing at higher temperatures. The hotend kit comes with a thermistor cartridge, with which temperatures up to 300°C can be reached.
The kit contains the following original parts:
- E3D thermistor cartridge 100k Ohm Semitec
- E3D aluminium heater block
- E3D heat break
- E3D brass nozzle 0.4mm
- E3D injection molded fan duct
- E3D aluminium heatsink
- E3D silicone sock for v6 hot ends (3 pieces! )
- E3D v6 Bowden clutch 1.75mm
- Fasteners (original)
The kit contains the following compatible parts:
- Axial fan 30 x 30 x 10mm 24V
- Ceramic heating cartridge 24V
- PTFE tube, 80cm
For the Marlin firmware you need the following thermistor setting:
#TEMP_SENSOR_N 5
